Freightliner Page 2

Pages 1, 2, 3, 4, 5, 6, 7, 8, 9,

Using installation tool  to install master harness.

  1. Attach Quick Control to shift lever using clamp kit provided.

  2. Attach master harness to Quick Control.

  3. Remove boot retaining ring first marking it to help align it to the holes in floor when replacing it.

  4. Moisten installation tool and insert it though top of boot pulling boot up from floor.

  5. Feed wires through installation tool and continue under carpet to the dash.

  6. Moisten installation tool and slide out of boot cut tape and remove tool, wire tie harness to shift.

Pages 1, 2, 3, 4, 5, 6, 7, 8, 9,